Electrical Systems
7.37
PVL Ignition Troubleshooting -- 1200cc Carbureted Domestic Engine -- Continued
b.Check the resistance of the coil without the
plug wires installed.
2. Open the electrical box and check for correct connec-
tions between the stator, CDI, coils, and terminal
board. Inspect the wiring for incorrect connections or
physical damage.
A.Verify the correct installation of the Orange Red / Pur-
ple jumper wire.
a. Disconnect the stator from the electrical box
at the stator connector.
b. Connect the negative test lead of the ohm
meter to the black wire coming from the
stator and leave it connected for the duration
of test 2.
c. Connect the positive test lead to an engine
ground.
+
_
1200-1600
ohms
Amp
Engin
e
Groun
d
Ignition
Coil
Ill. 3
(do not disconnect the
primary side of the coil)
SPECIFICATION: 1200 to 1600 ohms (Ill.3)
+
_
0-1
ohms
Amp
Stator Black Wire
Ill. 4
Engine Stud (Ground)
SPECIFICATION: 0 to 1 ohms (Ill. 4)
To Next Page
Loading...