Maintenance
2.8
General Lubrication -- Continued
Drive Shaft Lubrication
WARNING
The plastic driveshaft shroud is designed to protect you from dangerous moving parts. It must be rotated out of
the way to lubricate the driveshaft coupler. Follow the instructions below in order to avoid personal injury.
CAUTION:
Grease drive shaft coupler and bearing housing anytime water in the craft has been at or above the coupler level
to avoid damage to these parts. Refer to the preventative maintenance schedule on pages 2.2 and 2.3.
Bonded Rubber Couple r*
Driveshaft splines should be lubricated during pre-sea-
son maintenance, every 100 hours, or when pump is dis-
assembled. Sealing O-rings at impeller end and inside
coupler should be inspected and replaced if worn or
damaged. Refer to Final Drive section for driveshaft re-
moval procedure. Use Premium All Season Grease.
Bearing Housing*
Using a grease gun with a needle tip adaptor (PN
2871174) lubricate bearing housing at grease fitting until
grease purges past seals. Lubricate every 25 hours.
NOTE: *Refer to Preventative Maintenance Schedule on Pages 2.2 and 2.3.
All Season Grease PN 2871423
All Season Grease PN 2871322
Shroud
Forward
Lubricate
O-ring and
Splines
Bonded
Rubber
Coupler
Grease
Front of Watercraft
Bearing Housing
To Next Page
Loading...
Need help?
General
