Maintenance
2.22
Fuel System -- Continued
Fuel L ines / Vent Lines
1. Check fuel lines and vent lines for signs of wear,
deterioration, damage or leakage. Replace if
necessary. Ensure that clamps are tight.
2. Be sure all lines are routed properly and secured with
cable ties away from any moving parts.
CAUTION:
Make sure lines are not kinked or pinched.
Fuel Filter
The fuel filter should be replaced annually or whenever
sediment is visible in the filter.
1. Loosen line clamps at both ends of filter.
2. Remove fuel lines from filter.
3. Install new filter with arrow pointed in direction of fuel
flow.
4. Re-install and tighten clamps on fuel line.
5. Start engine and inspect for leaks.
CAUTION:
Never operate the engine for more than 15 seconds with-
out cooling water. Severe engine damage may occur from
overheating.
DIt Water Separatin g Filter
The water separating filter on DIt models require no
maintenance.
Arrow Indicates
Direction of Flow
To Next Page
Loading...
Need help?
General
