Symptom Problem Solution
Images are not shown
on TV.
Video cable is not connected
correctly.
Make sure the video cable is connected to the
TV “Video In” socket.
The video clip (AVI) le
cannot be played.
DirectX version is lower than
9.0
Install DirectX 9.0 or above. Visit http://www.
microsoft.com for more details.
The camera is detected by
the Windows and works
properly, but a driver letter
of the Removable disk is
not created.
The removable disk crashes
with the network drives.
Disconnect the crashed network drive and reserve
this drive letter for the camera.
I cannot activate my
Digital Camera by pressing
the Power switch.
Insufcient battery power or
battery is missing.
Recharge the batteries or install the batteries.
Camera does not turn on. Batteries are not oriented
correctly.
Or
Batteries are dead.
Orient the batteries correctly.
Or
Replace or recharge the batteries.
Camera suddenly powers
off.
Auto Power Off function is
activated.
Or
Batteries are dead.
Turn the camera on.
Or
Replace or recharge your batteries.
Image is not recorded
when the shutter button
is pressed.
Camera is turned off.
Or
Flash unit is charging.
Or
Memory is full.
Turn the camera on.
Or
Wait until ash unit charging nishes.
Or
Delete images you no longer need, or use another
memory card.
Camera powers off during
self-timer countdown.
Batteries are dead. Replace or recharge your batteries.
LCD screen image is out
of focus.
Macro mode is being used for
far subjects.
Or
Still image mode is being
used for near subjects.
Set the camera to Still Image mode.
Or
Set the camera to Macro mode for subjects this
close to the lens:
Wide Angle: 0.32 ft~ 3.3 ft (0.1 m ~ 1.0 m)
Telephoto: 1.3 ft ~ 3.3 ft (0.4 m ~ 1.0 m)
Recorded pictures are not
saved in memory.
Removing the memory card
before the save operation is
complete.
Do not remove the memory card before the save
operation is complete.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
