1 - 12
Brightness Adjustment and Self-Timer
To reshoot a picture that is too dark, move the Brightness Override Switch toward the white-dot arrow
(Figure 1-11). To take a darker picture, move the Switch to the left, toward the black-dot arrow. (Camera
must be erected; Switch will reset to normal when Camera is collapsed.)
To operate Self-Timer, set Camera on tripod, frame picture and slide switch toward clock symbol (it will
spring back). Camera will beep and red LED will flash at increasing rate during the next 12 seconds, then
strobe will fire. May be cancelled by pushing switch to right again, or collapsing Camera, or lightly touching
the shutter button.
Figure 1-11. Brightness (Lighten/Darken) and Self-Timer Controls
To Next Page
Loading...
Need help?
General
