4 - 4
Introduction
The following procedures and illustrations cover complete disassembly of the Vision Camera and all Vision
sub-assemblies. However, for many repairs, it is not necessary to completely disassemble the entire Vision
Camera. Only certain panels, subassemblies or adjacent parts need to be removed to gain access to the part
to be repaired or replaced. Reassembly procedures are provided for the more complex sub-assemblies (for
example, the shutter and the gear trains). To reassemble Vision Camera assemblies, follow the disassembly
procedures in reverse order.
Special Tools and Equipment Needed
Tools and equipment needed for the disassembly and reassembly of the Vision Camera subassemblies are:
• Battery Contacts GO/NO-GO Gauge (# 13558)
• Needlenose Pliers
• Tw eeze rs
• Dental Pick
• Square Drive Handle (# CPS 416)
• Square Drive Bit (# 13553)
• Jeweler's Screwdrivers
• Solder Aid Tool (# 941168)
• Narrow Blade (Notched) Flat Screwdriver (#13560)
• Mid-Link Installation Tool (# 13557)
• Dump Probe (# 13119)
• Shutter Support Fixture (# 13556)
To Next Page
Loading...
Need help?
General
