POLMAR RX-1300 - Fine-Tuning Frequency with Control Knob; Adjusting Frequency in 1 MHz Steps; Adjusting Frequency in 10 MHz Steps

To Next Page

To Previous Page

Using the Control Knob

First select the required starting frequency using the Direct Frequency Input method, then

rotate the Control knob to step up or down in frequency from the starting point. The fre-

quency will change in the selected frequency step.

•To change frequency in 1 MHz steps, press the Func key, then press the ▲ or ▼ keys to

change the frequency. (F is displayed while the Func mode is active).

•To change frequency in 10 MHz steps, press the Func key, then rotate the Control knob to

change the frequency. (F is displayed while the Func mode is active).

Note:

The Func mode clears a few seconds after the last key press or control knob change.