POLMAR RX-1300 - Priority Search Functionality; Priority Search Using a Frequency; Priority Search Using a Stored Channel

54
Priority Search
Priority Search allows you to insert a Priority Channel into the frequency Search. When the
Search is activated, the receiver will visit the Priority channel or frequency at an interval
set by the ‘Priority Time’ in the Menu setup.
To perform a Priority Search using a frequency as the Priority channel:
1. Enter the required Priority channel frequency using the
Keypad then press E/VFO.
2. Press Func PRI. The selected frequency is now the Prio-
rity Channel.
3. Press Band/Bank to select the required frequency band
you wish to scan.
4. Press Scan/Src. The receiver will begin searching the se-
lected Band and will switch to the Priority channel at an in-
terval set by the ‘Priority Time’ setting in the setup menu.
To perform a Priority Search using a stored channel as the
Priority channel:
1. Press Func MR to select the Memory Read mode.
2. Press Bank/Band to select the required memory bank.
3. Rotate the Control Knob to select the required channel.
4. Press Func PRI. The selected channel is now the Priority
Channel.