56
Memory banks
The scanner memory storage area has a capacity of 1300 locations. These are split into
specicsegmentsasfollows:
1000 Manual Storage Memories.
200 Automatic Storage Memories
50 Limited Search Memories (2 x 25 pairs)
50 Dual Watch memories (2 x 25 Pairs)
Manual Memories
The Manual Memory area allows the user to manually store up to 1000 individual frequen-
cies. It is split into memory banks with a maximum capacity of 40 memory banks, each
containing 25 memory locations (40 x 25 = 1000).
Howeverthememorycapacityofeachbankisexibleuptoamaximumof100memories
per bank, but at a reduction in the number of banks available.
For example, in an extreme case where each bank is programmed with the maximum 100
memories, the number of banks available would be reduced to 10 (10 banks x 100 memo-
ries = 1000 memory capacity). The default Manual memory banks are labelled 00 to 39.
Automatic Memories
The Automatic Memory area can store up to 200 frequencies in two banks of 100 memo-
ries. The automatic memory is used when searching a band of frequencies. The scanner
can automatically store any active frequencies it nds while searching. The Automatic
Memory banks are labelled A0 and A1
Limited Search Memories
The Limited Search Memories consists of 50 memory locations split into 25 pairs of fre-
quencies. The Limited Search function allows you to specify the upper and lower frequency
limits of a section of frequency band that you wish to scan. These frequency limit ‘pairs’
can be stored in the Limited Search memories for recall at a later time.
TheLimitedSearchMemoryUpperandLowerlimitsareidentiedasAandb.
The 25 pairs are therefore labelled A00, b00 to A24, b24
Dual Watch Memories
The Dual Watch function allows the radio to switch between two selected frequencies. The
Dual Watch Memories consists of 50 memory locations split into 25 pairs of frequencies.
ThetwoDualWatchfrequenciesareidentiedasAandb.The25pairsarethereforela-
belled A00, b00 to A24, b24.