2. At startup, use the out of box setup wizard to pair the Poly TC10 or Poly TC8 to your Poly Studio
G62 system.
If you're setting up a new system, you can use the Poly TC10 or Poly TC8 to out of box the touch
controller and the system at the same time.
Connect IP microphones to the Poly Studio G62 system
Connect up to three Poly IP microphones to the Poly Studio G62 system.
NOTE: The Poly Studio G62 system LLN port doesn't provide power to connected peripherals. Use
a PoE Ethernet switch or PoE injector to power your Poly IP peripherals.
1. To provide power to your Poly IP microphones, connect a supported Ethernet switch, such as a
Netgear A/V Line M4250 GSM4210PD, to the LLN port on the Poly Studio G62 system.
If you're connecting only one Poly IP microphone, you can use a PoE injector.
2. Using the cables supplied with your Poly IP microphones, connect the microphones to the
Ethernet switch.
Alternatively, you can connect the microphones using a CAT5e, CAT6, or CAT7 direct STP
Ethernet cable. The cable can be up to 91 m (300 ft) in length.
3. After powering on your system, finish setup by accessing the system web interface.
a. In the system web interface, go to Device Management > Available Devices.
b. Next to the Poly IP microphone entry, select Pair.
Connect a USB camera to the Poly Studio G62 system
Connect a supported or compatible USB camera to your Poly Studio G62 system.
Connect IP microphones to the Poly Studio G62 system
9
To Next Page
Loading...
