Poly Studio G62 - 5 Using the Poly Studio G62 System; Configuring Your Poly Studio G62 System; Access the System Web Interface; Navigating the Poly Studio G62 System Interface

Using the Poly Studio G62 system5
After connecting peripherals and powering on your Poly Studio G62 system, you can begin using the
system with your chosen conferencing provider.
Configuring your Poly Studio G62 system
You can configure your Poly Studio G62 system using multiple options.
To configure the system and change settings, use one of the following options:
● Access the system web interface
● Onboard your system to Poly Lens Cloud
● Onboard your system to Poly Clariti
● Use CLI or REST APIs
For advanced configuration information including network setup and security settings, see the Poly
Video Mode Administrator Guide and the Poly Partner Mode Administrator Guide .
Access the System Web Interface
Access the system web interface to perform administrative tasks.
IMPORTANT: If not prompted to do so during setup, Poly recommends changing the administrator
password in the system web interface.
1. Open a web browser and enter the system IP address.
When setting up your system, the onscreen instructions display the IP address to use.
2. Enter the username (the default is admin).
3. Enter the password (the default is the last six characters of your system’s serial number).
The user name and password are case sensitive.
Navigating the Poly Studio G62 system interface
The conferencing provider that you choose determines the options for navigating the system.
After setting up your system, you can navigate the system using one of the following controllers:
14
Chapter 5Using the Poly Studio G62 system