Poly Studio G62 - 4 Setting up the Poly Studio G62 System; Complete the out of Box Setup and Choose a Provider

Setting up the Poly Studio G62 system4
After connecting the peripherals, you can power on and set up your system.
You can set up the system using one of the following methods:
● Using the out of box setup on a Poly TC10 or Poly TC8 touch controller
The Poly TC10 or Poly TC8 must be on version 6.0 or later and connected to the same subnet as
the Poly Studio G62 system.
● Accessing the system web interface
● Onboarding the system to Lens Cloud
Complete the out of box setup and choose a provider
After connecting peripherals to the Poly Studio G62 , power on the system and complete the out of
box set up on a connected Poly TC10 or Poly TC8.
IMPORTANT: Poly strongly recommends that you update your system to the latest Poly VideoOS
version. Updating your system ensures that you have access to the latest Poly Studio G62 system
features and functionality.
1. Connect the Poly TC10 or Poly TC8 to a PoE-enabled Ethernet port on the same subnet as the
Poly Studio G62 system.
The Poly TC10 or Poly TC8 powers on and displays the out of box screen.
2. Connect the Poly Studio G62 system to a PoE+ Class 4 Ethernet port on the same subnet as the
Poly TC10 or Poly TC8.
The system powers on and displays the Connect a Controller screen including the system IP
address and the serial number.
3. On the Poly TC10 or Poly TC8, select Get Started.
4. Review the network and regional details, then select the right arrow.
5. Select Room Controller and select the right arrow.
The Poly TC10 or Poly TC8 searches for the Poly Studio G62 system in the out of box state and
displays the results.
12
Chapter 4Setting up the Poly Studio G62 system