Poly Studio G62 - Poly Studio G62 LED Behavior; Powering the System on and off; Power on Your Poly Studio G62 System

Poly Studio G62 LED behavior
Use the LED on the front left corner of the Poly Studio G62 system to get information on the state of
your system.
Table 2-2 Poly Studio G62 LED Behavior
Indicator Status
Blinking white Powering on
Solid white Powered on
Solid green In a call
Blinking amber Update in progress
Solid amber Sleeping
Blinking red Error preventing normal operations
Solid red Muted microphone
Powering the System On and Off
The system powers on when you plug it in to a power source.
Poly recommends the following when powering off or restarting your system:
● Don’t restart or power off the system during maintenance activities (for example, while a software
update is in progress).
● If a system restart is necessary, use the system web interface, RestAPI, Telnet, or SSH. If
possible, avoid removing power to restart the system.
Power on your Poly Studio G62 system
You can use a PoE+ class 4 injector or a PoE+ class 4 Ethernet connection to power your system.
The Poly Studio G62 system doesn't include a power button. The system powers on when connected
to a PoE+ class 4 injector or Ethernet switch. If your PoE connection doesn’t provide sufficient power,
the system LED changes to blinking red, and the following message displays on the monitor:
"Insufficient Power from System Ethernet Port"
4
Chapter 2Getting Started