6. Use the system IP address to select your Poly Studio G62 system from the results and select the
right arrow.
Alternatively, select Manually Connect to a Room and enter the Poly Studio G62 system IP
address.
7. If the room requires further authentication, the Poly Studio G62 system display shows a
collection of shapes. Select the sequence of shapes on the Poly TC10 or Poly TC8 that matches
the sequence of shapes on the Poly Studio G62 system display and select Confirm.
8. Depending on the Poly Studio G62 system configuration, the Poly TC10 or Poly TC8 displays
some of the following screens.
● Poly Lens registration
● Provider selection
● Option to update software if a software update is available
The Poly TC10 or Poly TC8 and the Poly Studio G62 system restart into the chosen partner
application.
Complete the out of box setup and choose a provider
13
To Next Page
Loading...
