System Flags
Polycom, Inc. 197
ITP_CROPPING If the conference is set to telepresence mode,
cropping of the image is done according to this flag
value:
Default value: ITP
Possible values:
• ITP (default) - No cropping of left-right, symmetric
cropping of top-bottom.
• CP - Symmetric cropping of both left-right and
top-bottom areas (separately calculated).
• MIXED - Symmetric cropping of left-right areas
and asymmetric cropping of top-bottom areas
(16% from top, 84% of bottom).
Note: If the flag was added with no value, and the
conference is set to telepresence mode, the left-right
areas aren’t cropped, and the top-bottom areas are
asymmetrically cropped (16% from top, 84% from
bottom).
HW/VE No
IVR_MESSAGE_VOLUME The volume of IVR messages varies according to
the value of this flag.
Default values: 6
Possible values:
0 – disables playing the IVR messages
1 – lowest volume
10 – highest volume
Note:
• It is not recommended to disable IVR messages
by setting the flag value to 0.
• System reset is not required for flag changes to
take effect.
HW/VE No
IVR_MUSIC_VOLUME The volume of the IVR music played when a single
participant is connected to the conference varies
according to the value of this flag.
Default value: 5
Possible values:
0 – disables playing the music
1 – lowest volume
10 – highest volume
Note: System reset is not required for flag changes
to take effect.
HW/VE No
IVR_ROLL_CALL_SUPPRESS_OP
ERATOR
When set to YES, the MCU suppresses the
entry/exit tone when the operator participant joins or
leaves the conference.
Default value: NO
Possible values: YES/NO
HW/VE No
General System Flags
Flag Name Description Platform Add?
To Next Page
Loading...
