Appendix - Polycom Open Collaboration Network (POCN)
Polycom, Inc. 386
CUCM
1 Configure the CUCM to send and receive calls from the H.323 network.
a With Neighbored IOS and DMA/Resource Manager Gatekeepers
For more information see the Polycom Unified Communications Deployment Guide for Cisco
Environments, Configuring Cisco Unified Communications Manager for H.323.
b With Resource Manager Gatekeeper
For more information see the Polycom Unified Communications Deployment Guide for Cisco
Environments, Configuring Cisco Unified Communications Manager for H.323.
c With IOS Gatekeeper
For more information see the Polycom Unified Communications Deployment Guide for Cisco
Environments, Configuring Cisco Unified Communications Manager for H.323.
IOS Gatekeeper
● Set up zones and gateway type prefixes to enable dialing to DMA and Collaboration Server systems.
For more information see the Polycom Unified Communications Deployment Guide for Cisco
Environments, Configuring the Cisco IOS Gatekeeper.
IOS and DMA/Resource Manager Gatekeepers (Neighbored)
● Configure the Cisco IOS Gatekeeper for two separate zones.
For more information see the Polycom Unified Communications Deployment Guide for Cisco
Environments, Configure the Cisco IOS Gatekeeper for use with a Resource Manager System.
Polycom Equipment
The following table lists the Polycom products supported within the various Deployment Architecture.
Only Collaboration Server configurations are described in detail in this document.
Configuration procedures for all other solution components are described in the Polycom Unified
Communications Deployment Guide for Cisco Environments.
Supported Polycom products
Polycom TIP and SIP Version(s)
Polycom DMA 7000 system V4.0
Polycom RealPresence Collaboration Server V7.6 and higher
Immersive Telepresence Systems:
• RPX 200 and 400 systems
• OTX 300 system
• TPX HD 306 system
• ATX HD 300 system
V3.0.3
Requires TIP option key.
Requires Polycom Touch Control.
To Next Page
Loading...
