Polycom VVX 411 - Placing Calls; Calling from the Dialler

Polycom VVX 411 – full user guide v1.1
If you press a line key that doesn’t have an active call, the most recent call on that line will become active. The
current call will be held. To manage a call, use the up and down keys to highlight it. Then, press one of the soft
keys to hold, resume, end, or transfer the highlighted call, or set up a conference with the highlighted call.
Placing Calls
You can place a call using the handset, speakerphone, or headset. You can dial the number first, and then
choose the method — by picking up the handset, pressing , or pressing — or choose the method first, and
then dial the number. You can place calls in these ways:
• Manually, from the dialler
• Automatically, by tapping a favourite in Home or Lines view
• Automatically, from your Favourites list, Recent Calls list, or Contact Directory
Calling from the Dialler
The Dialler displays a list of previously-placed calls. Select
one of the entries to automatically enter it. Or, start entering
a number. As you enter numbers, the Dialler displays a list of
similar numbers, as shown next. Use the up and down arrow
keys to select a match and automatically enter it.
To display the Dialler, do one of the following:
• From Home view, select New Call.
• From Lines or Calls view, press New Call. (The New
Call soft key won’t display if you have an active call.)
• If your phone is idle, start entering a phone number.
• Pick up the handset, or press or . This method only works if you don’t have an active call.
• In Lines view, press a line key that doesn’t have any calls.
When you access the Dialler, an active call is held.