Polytec PSV-I-500 User Manual

1-9
1 Safety Information
1.3.6 Equipment for PSV-500 Standard
Safety
equipment
• You can switch on or off the laser with the key switch on the front-end.
• You can switch on or off the laser using the software.
• The geometry laser has to be switched on additionally via the software.
Thereby the object laser is switched off.
• You can block the laser with a beam shutter on the scanning head.
• An emission indicator on the scanning head indicates the activity of the
installed laser and thus the potential hazard of laser beams emitted.
• You can only remove the key if the front-end and therefore also the laser
is switched off.
1.3.7 Equipment for PSV-500 Xtra
Safety
equipment
• You can switch on or off the green pilot laser and the infrared object laser
with the key switch on the front-end. The green pilot laser and the invisible
object laser will then light up immediately.
• You can also switch on the geometry Laser via the software, thereby the
pilot laser is switched off. Pilot laser and geometry laser cannot be
switched on simultaneously (refer also to S
ECTION 1.3.5).
• You can switch on or off the lasers using the software.
• You can block the lasers with a beam shutter on the scanning head.
• An emission indicator on the scanning head indicates the activity of the
installed lasers (i.e. the mains supply of the lasers is active) and thus the
potential hazard of visible and invisible laser beams.
• You can only remove the key if the front-end and therefore also the lasers
are switched off.

Polytec PSV-I-500 Specifications

General

Brand	Polytec
Model	PSV-I-500
Category	Measuring Instruments
Language	English