3-10
3 First Steps
Back view
The back view of the scanning head is shown in the following figure.
Figure 3.8: Back view of the scanning head
1
Transport handle
2SIGNAL
level display
Measure for the light scattered back from the measurement surface. The signal
level display is deactivated when the geometry laser (Geo-Laser) is activated.
3 LASER
L
ED
L
ED
is lit up: cabled correctly, laser switched on
4 10-32 UNF-2B
thread
Connection for the optional vibration sensor. The vibration sensor is used to
compensate ambient vibrations.
5OPTION
connection (7-pin circular jack)
Connection for the connecting cable to the PSV-A-T11 pan-tilt head (only
PSV-1D) to control the pan-tilt head via the software.
With EXT option:
OPTION
connection (8-pin circular jack)
Connection for the connecting cable or the bridging plug to the external scanner
control
6
Main connection (industrial-style connector)
Connection for the main cable (Umbilical) to the front-end/to the junction box
7
Name plate
Plate with information on model, serial number, power specifications, etc.
LASER
SIGNAL
OPTION
10-32
UNF-2B
2
3
5
1
4
6
7
To Next Page
Loading...
