User manual Pomac PLP Lobe pump
40 CE/PLP (1406) EN-12
7.16. Gearbox assembly
See paragraph 9.4 for drawing and parts list of the referenced parts.
1. Place a new gasket (11) into the gearbox cover (28).
2. Fit the gearbox cover to the rotor case with Allen screws (31).
In case they are disassembled, fit the parts as described below, into the gearbox. The positions
are indicated starting at the back of the pump. Attention: if the pump is mounted in a self-
draining position, the gearbox is mounted in a FLAT position!
3. Fit the plugs (27) into the holes at the bottom and right side of the gearbox
4. Fit the oil sight glass (24) into the hole at the left of the gearbox.
5. Fit the oil fill plug (25) into the hole on top of the gearbox.
To Next Page
Loading...