User manual Pomac PLP Lobe pump
CE/PLP (1406) EN-12 7
1. Introduction
1.1. General information
This manual provides important information regarding the correct way of installing, operating
and servicing this pump.
This manual also provides information necessary to prevent the installer/operator from injury or
discomfort during installation and operation of this pump and to ensure the correct use and
reliable performance of this pump.
This manual represents the most recent information regarding the pump types mentioned in this
manual at the time of going to print. However, POMAC reserves the right to modify the
construction of the pump types mentioned, as well as the contents of this manual, without prior
or afterward notification.
Read this manual thoroughly before installing, operating or servicing this pump. Ensure
that operators and maintenance staff are familiar with the symbols used. Follow the
instructions in this manual step by step.
1.2. Warranty
Warranty is strictly limited to the conditions specified by POMAC and will only be granted
according to these conditions.
Warranty will only come into force provided that:
⚫ the pump has been installed and put into operation strictly in accordance with the
instructions given in this manual.
⚫ maintenance and repairs have been carried out according to the instructions given in this
manual.
⚫ exclusively original POMAC parts or parts provided by POMAC have been used for replacing
parts.
⚫ the pump has not been used for applications other than those shown in the specifications
according to which the pump was sold.
⚫ no changes have been made to the construction of the pump itself by the buyer.
⚫ the damage is not the result of work carried out by persons not qualified or appointed.
⚫ the damage has not been caused through major force.
1.3. Transport and receipt
⚫ Check to see if the pump has not been subject to damage during transportation. If this is the
case, report it directly to the carrier and to POMAC;
⚫ If the pump is delivered on a pallet, leave it on the pallet for as long as possible. This
facilitates internal transport.
1.4. Manufacturer
PLP lobe pumps are manufactured by
Pomac bv
Feithspark 13
9356 BX Tolbert
The Netherlands
Tel +31(0) 594 512877
Fax +31(0) 594 517002
info@ pomacpumps.com
www.pomacpumps.com
To Next Page
Loading...