UPS Maintenance
61
Powerware
®
9125 User’s Guide (2500–3000 VA) : Rev B www.powerware.com
4. Unscrew and set aside the battery retaining bracket.
Battery Retaining Bracket
5. Pull the batteries out onto a flat, stable surface. See “Recycling
the Used Battery” on page 62 for proper disposal.
6. Slide the new batteries into the UPS.
7. Reinstall the battery retaining bracket removed in Step 4.
8. Reconnect the battery cable.
9. Snap the LED panel into place.
10. Replace the front panel.
Testing New Batteries
Press and hold the button for three seconds to initiate a self-test.
After the five-second test is complete, the
indicator should turn off
(it may take a few seconds to turn off). If the
indicator stays on,
check the battery connections. Call your service representative if the
problem persists.
To Next Page
Loading...
