What to do if there is a mains breakdown in PowerWave Repeater?
If your PowerWave Repeater indicates a mains breakdown, it means the main power supply is unavailable. To address this, use an external relay to indicate the mains breakdown. Connect the external relay to External Alarm 1 and configure the repeater to indicate this alarm.
What to do if GPS device cannot find satellites in PowerWave AR1200 Repeater?
If the GPS device on your PowerWave Repeater cannot find any satellites, check the GPS antenna and cables. If you are using an active antenna, ensure that the jumper switch is set accordingly and that the power supply for it is correctly configured, as a faulty or wrongly configured power supply could be the cause.
What to do if DC voltage on FON PCBA is out of range in PowerWave AR1200?
If a DC voltage on a FON PCBA of your PowerWave Repeater is out of range, replace the FON PCBA.
What to do if FON 10 Volt charger voltage is below limit in PowerWave AR1200 Repeater?
If the FON 10 Volt charger voltage is below the limit in your PowerWave Repeater, replace the FON.
What to do if GPS device cannot be detected on PowerWave AR1200?
If the GPS device cannot be detected on your PowerWave Repeater, check the GPS PCBA.
To Next Page
General