C842, C842i, C846, C846i Upright and Recumbent Cycle
Page 13
17. The serial number of the unit will be displayed or NO SERIAL NUMBER. If a serial number
has not been entered into memory. The serial number is in the upper PCA memory,
therefore if the upper PCA is replaced or installed on a different C846 the serial number will
be lost or incorrect.
18. Press the ENTER or RESET key to exit the program.
19. The odometer will be displayed, in total revolutions, as REVOLUTIONS XXXXXX.
20. Press the SELECT key to continue to the total hours display.
21. The total hours the bike has been used will be displayed as HOURS XXXX.
22. Press the SELECT key to continue to the software display.
23. The upper and lower software versions will be displayed as UPPER SW: VER XX.X
LOWER SW: VER XX.X.
24. Press the SELECT key to continue to the error log.
25. The first (most recent) error will be displayed or the message NO ERRORS will be displayed
if the log is empty. The
î and î keys will move you through the log. Pressing and holding
the QUICK START will allow you to clear the error log.
26. Press the RESET key to exit the program.
To Next Page
Loading...
Need help?
General
