C842, C842i, C846, C846i Upright and Recumbent Cycle
Page 7
Procedure 3.1 - Software Access Codes
The C842 C846 and C846i use the standard access codes to provide access to the various
software features. In using the standardized access codes the keys are hypothetically numbered
left to right with key #1 on the far left and key #7 on the far right. On the version 1 display, key #6
is a hidden key on the display panel and is functional. When it is necessary to use key #6, press
midway between the CHANGE key (key #5) and the QUICK START key (key #7). The standard
access codes use all sequential key presses. The allowable delay between key presses is short.
If too much time is taken between key presses the access procedure will be aborted. If the
access is aborted, it will be necessary to start over from the beginning. See Diagram 3.1 for C846
version 1 displays and Diagram 3.2 for C846 i and C846 version 2 displays. The C842 display is
not illustrated. The same access code procedures are used on the C842 as on the C846 version
2.
Standard Access Codes
Diagnostics Keys RESET,5,1,7,6,5,7,6,1
Odometer Keys RESET,6,5
Club Settings Keys RESET,5,6,5,1,5,6,5
Diagram 3.1 - C846 Display (version 1)
Key #1
RESET
Ke
To Next Page
Loading...
Need help?
General
