C842, C842i, C846, C846i Upright and Recumbent Cycle
Page 12
Procedure 3.3 - Displaying the Odometer
Procedure
1. For C846 version 1 units, set the on/off switch in the “on” position. You must continue
pedaling while performing this procedure.
2. With the banner scrolling, press keys RESET,6,5, sequentially until the message. The total
revolutions will be displayed.
3. For C842 and C842i units, skip to step 19. For C846i and C846 version 2 units, skip to step
8. For C846 version 1 units, continue with step 4.
4. Press the ENTER key and the total hours of usage will be displayed.
5. Press the ENTER key and the software version will be displayed.
6. Press the ENTER key and the first entry of error code log will be displayed. Use the
and
keys to view all of the error code log entries.
7. Press and hold the RESET key to exit the ODOMETER program.
8. The display will momentarily read INFORMATION DISPLAY.
9. The display will momentarily read ODOMETER.
10. The odometer will be displayed as XXXXX REVOLUTIONS. Press the ENTER key to
continue to the hour meter display.
11. The display will momentarily read HOUR METER.
12. The hour meter will be displayed as XXX HOURS. Press the ENTER key to continue to the
software version display.
13. The display will momentarily read SOFTWARE VERSION.
14. The software versions will be displayed as UPPER X.XX LOWER X.XX. Press the ENTER
key to continue to the error log display.
15. The first (most recent) error will be displayed or the message NO ERRORS will be displayed
if the log is empty. The
and keys will move you through the log. Pressing and holding
the QUICK START will allow you to clear the error log. Press the ENTER key to continue to
the serial number display
16. The display will momentarily read SERIAL NUMBER.
To Next Page
Loading...
Need help?
General
