C842, C842i, C846, C846i Upright and Recumbent Cycle
Page 47
Procedure 7.4 - Replacing All or Part of a Seat Carriage
Assembly (Recumbent Cycle)
Note:
The seat carriage assembly was modified on April 1, 2000. If you have a unit manufactured prior
to April 1, 2000 and are experiencing a problem with the seat rocking, it is recommended that the
seat carriage be upgraded by installing a 58012-101 seat carriage upgrade kit. The seat carriage
and seat carriage parts described in this procedure refer to the seat carriage assembly
manufactured starting April 1, 2000.
1. For C842, C846i and C846 version 2 units, skip to step 15. For C846 version 1 units,
continue with step 2.
2. Set the on/off switch in the off position.
3. The seat carriage assembly consists of the following: carriage, seat, wheels and seat
adjustment assembly (See Diagram 7.4).
Diagram 7.4 - Seat Assembly
4. Remove the two seat stops (one each side) from the rear portion of the frame that the seat
slides on. Remove the end cap from the frame. See Diagram 7.8.
5. Lift up on the seat adjustment lever and slide the seat assembly off of the rear of cycle’s
frame. Place the seat assembly upside down on a solid work surface.
6. If you are replacing the seat, remove the screws that fasten the seat to the carriage. Set the
replacement seat on the carriage, hand start all of the seat mounting screws. Tighten all of
the seat mounting screws.
Carriage
Seat
Seat Adjustment Lever
Roll Pin, Adjustment Lever
Roll Pin, Housing
To Next Page
Loading...
Need help?
General
