C842, C842i, C846, C846i Upright and Recumbent Cycle
Page 17
Section Four - Checking C842, C842i, C846 or C846i
Operation
This section provides you with a quick method of checking operation.
Procedure
1. On C846 version 1 units, set the on/off switch in the “on” position.
2. Start pedaling.
3. With the banner displayed, press QUICK START.
4. Select Resistance Level 1 and press ENTER.
5. Operate the C842, C846 or C846i for 4–5 minutes. As you operate the bike, concentrate on
the operating sounds made by the unit. Be on the alert for unusual rubbing, hitting, grinding,
or squeaking noises.
6. If the bike makes unusual noises or the electronic display does not change appropriately,
troubleshoot per Section 6.
7. Press the RESISTANCE
▲ key until you reach Resistance Level 10. Operate the C846 for
another 2–3 minutes.
8. If the resistance does not change or the operation of the bike feels inconsistent compared
with Resistance Level 1, troubleshoot per section 6.
9. Press the RESISTANCE
▲ key until you reach Resistance Level 20. Operate the bike for
another 2–3 minutes.
10. If the resistance of the bike does not change or operation feels inconsistent with Resistance
Levels 1 and 10, troubleshoot per Procedure 6.5.
11. Check the LED’s mounted on the upper PCA and the function keys displayed on the
electronic console by performing Procedure 3.2.
To Next Page
Loading...
Need help?
General
