C842, C842i, C846, C846i Upright and Recumbent Cycle
Page 60
9. Test the operation of the cycle per Section 4.
10. Replace the cover per Procedure 7.1.
11. If the cycle is equipped with an external power adapter, disconnect the power adapter from
the cycle.
12. Remove left side cover.
13. Disconnect the positive (red) and negative (black) wires from the battery. Remove the two
screws that fasten the battery bracket to the frame. Remove the battery and battery bracket.
14. PLace the battery bracket on the replacement battery and set them in their mounting
position with the positive terminal (red dot) to the left side of the bike. See Diagram 7.16.
Diagram 7.16 - Battery, C842i, C846i and C846 version 2
15. Fasten the battery bracket with battery to the frame with the screws removed in step 13.
16. Connect the red wire to the battery’s positive terminal (red dot) and the black wire to the
battery’s negative terminal.
Red Wire
Red Dot
Battery
Bracket
Battery
To Next Page
Loading...
