Precor C842 - Page 69

C842, C842i, C846, C846i Upright and Recumbent Cycle
Page 69
7. Replace the cover per Procedure 7.1.
8. Remove the right side cover.
9. Loosen but do not remove the locknut retaining the idler pulley. See Diagram 7.23. This will
remove tension from the primary belt.
Diagram 7.23 - Primary Drive Belt, C842, C842i, C846i and C846 version 2
10. Remove the primary belt. Route the replacement primary belt around the primary pulley,
over the idler pulley and around the secondary axle as shown in Diagram 7.23.
11. Tension the primary belt per Procedure 5.1.
12. Replace the right side cover.
Primary
Pulley
Idler Pulley
Primary
Belt
Secondary
Axle
Cover
Pulley