C842, C842i, C846, C846i Upright and Recumbent Cycle
Page 74
Procedure 7.17 - Replacing the Secondary Pulley,
Intermediate Pulley or Secondary Bearings
1. For C842, C842i, C846i and C846 version 2 units, skip to step 14. For C846 version 1 units,
continue with step 2.
2. Remove the primary drive belt per Procedure 7.14, steps 1-3.
3. Remove the secondary drive belt per Procedure 7.15, steps 1-4.
4. Remove the retaining clip from the secondary shaft. Slide the Secondary pulley off of the
intermediate shaft.
Diagram 7.27 - Secondary Pulley
5. If you are not replacing the intermediate shaft/pulley assembly, skip to step 6.
6. Slide the intermediate shaft/pulley assembly out of the frame.
Diagram 7.28 - Intermediate Pulley
Retaining Clip
Secondary Pulley
Intermediate Pulley
To Next Page
Loading...
