C842, C842i, C846, C846i Upright and Recumbent Cycle
Page 83
12. Thread the 32 mm nut, removed in step 4, onto the left side of the primary axle and torque it
60 inch-pounds.
13. Route the primary belt around the primary pulley, over the idler pulley and around the
secondary axle as shown in Diagram 7.23.
14. Tension the primary belt per Procedure 5.1.
15. Replace the crankarm covers and fasten them with the hardware removed in step 3.
16. Replace both the left and right hand pedals. Refer to Procedure 7.2.
17. Replace both covers and thoroughly test the bicycle per Section 4
To Next Page
Loading...
