Precor P80 - Page 42

© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law Page 40
Test
Equipment
Description
USB Test
All
1 Touch
USB Test
.
2 The USB Test will show the number of USB ports currently
active, there should be six. Insert a USB Flash drive into the
USB port and then Touch CLOSE, and then Touch USB Test
again. The number of active USB ports should be increased
by one.
3 Touch
CLOSE
to exit to
Systems Test
.
Touchscreen
Test
All
1 Touch
Touchscreen Test
.
2 Place your finger on one corner of the screen and run it
around the edges multiple times.
3 The line drawn by your finger should be very close to
previous passes. Be sure that you do not touch anything
else with your other hand.
4 Touch
FINISH
to exit to Systems Test.
Touchscreen
Calibration
All
1 Touch
Touchscreen
Calibration
.
2 A
+
will be displayed on a white screen. Touch the
+
, the
spot you just touched will disappear and then be replaced
with another
+
in a different location on the white screen.
3 Continue to touch the
+
as they appear on the screen until
the test automatically exits to the Systems Test screen.
You cannot exit this test until all the
+
have been touched
and the screen is calibrated.
Backlight Test
All
1 Touch
Backlight Test
2 The backlight will display three levels of brightness, 100%,
60%, and 0% in succession in 1 second intervals, returning
to the
System Tests
menu when complete.
RGB Test
All
1 Touch
RGB Test
.
2 The full screen should move through a succession of five
colors, requiring a touch anywhere on the screen to
advance to the next. These are Red, Green, Blue, Black,
White, returning to the
Systems Tests
menu when all the
displayed colors have been touched.
Speaker Test
All
1 Touch
Speaker Test
.
2 This test will send an audible sound to the speaker
mounted in the headphone jack and while providing a
graphic of a scrolling bar on the screen. When the test is
complete it will automatically exit to the
Systems Tes
t
screen.