tight, continue procedure to adjust the chain tension.
Chain adjustment instructions
1.
Remove the front chain guard access panel by removing the one fastener using a 5
mm hex key.
\
2. Remove all brake pad flywheel resistance by turning the resistance knob counter clock-
wise (-).
3.
Loosen the left and right axle nuts enough to allow axle movement using a 19 mm
wrench.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 13
4 Adjustment Procedures
Chain Drive Tension Adjustment
To Next Page
Loading...
