Chain Drive Tension Adjustment
About
This procedure provides instruction to verify and make adjustments to the chain drive. The
chain tension should be verified anytime the chain is replaced, at regularly scheduled pre-
ventative maintenance, or when there are any unusual belt related issues (noises, pedal skip,
etc.) while operating the bike.
CAUTION: Improper chain adjustment will cause premature wear and may void the
Precor Limited Warranty.
Specifications
System Component Specification
Chain Drive Tension 1/2 in (1.3 cm) up/dwn travel
Axle Nut torque 29.5 ft-lbs (40 Nm)
Available Movies
(Internet Only)
Chain Tension Adjustment
Procedure
Review entire procedure before starting.
Chain tension verification
1. First verify the chain tension by inserting a screwdriver into the chain tension inspection
window (rear chain guard) and gently moving the chain up and down. A properly
adjusted chain will have 1/2 in (1.3 cm) up/dwn travel. If the chain is too loose or too
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 12
4 Adjustment Procedures
Chain Drive Tension Adjustment
To Next Page
Loading...
Need help?
General
