Precor Spinner Ride Series User Manual

Chain Drive Issues
Applies To
All chain drive spinner series bikes.
Issues
Issues related to the chain drive bikes:
l Issues
ISSUE CAUSE SOLUTION
Excessive
chain noise.
l Chain tension is either to
loose or tight.
l Chain misaligned.
Verify and adjust chain tension, see "Chain
Drive Tension Adjustment" on page12.
If tension is within spec, inspect belt condition
and replace if worn, see "Belt and Flywheel
Replacement" on page22.
Scraping rub-
bing noise
from flywheel.
Flywheel misaligned
and rubbing frame
forks.
Check chain sprocket alignment, see "Chain
Drive Tension Adjustment" on page12.
Jerky pedal
movement.
Chain is skipping teeth
due to:
l Chain tension to loose.
l Worn chain.
l Worn sprocket teeth.
Verify chain tension. If tension within spec,
check the condition of chain and sprocket teeth,
replace as necessary, see "Chain Drive and Fly-
wheel Replacement" on page28.
Chain comes
off sprocket.
Bad front/rear sprocket
chain alignment.
Verify the chain sprocket alignment, see "Chain
Drive Tension Adjustment" on page12.
See Also
"Troubleshooting" on page58
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 61
6 Troubleshooting
Chain Drive Issues

Precor Spinner Ride Series Specifications

General

Brand	Precor
Model	Spinner Ride Series
Category	Exercise Bike
Language	English