Handlebar Adjustment Knob Replacement
About
This procedure provides instruction to remove and install the Handlebar Adjustment Knob.
Procedure
Review entire procedure before starting.
Removal Instructions
1. Remove the handlebar assemble off the post slider, see "Handlebar Adjustment Knob
Replacement" above.
2. Fully tighten the handlebar adjustment knob. This will push the locking nut slightly above
the bottom edge of the adjustment knob bracket exposing the locking nut.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 35
5 Replacement Procedures
Handlebar Adjustment Knob Replacement
To Next Page
Loading...
