Precor Spinner Ride Series - Console Installation and Set up; Cadence (RPM) Sensor Installation; Heart Rate Belt Bluetooth Pairing; Service and Maintenance

Console installation and Set Up
l Batteries Required: three AAA batteries.
For instructions to install the console, see the the SPINNING® STUDIO Owner's Manual
"Console Setup",see Operator's Guide.
Cadence (RPM) sensor installation
l Batteries Required: one CR2032 lithium coin cell battery.
For instructions to install the cadence sensor, see the Cadence Sensor Installation chapter in
the SPINNING® STUDIO Owner's Manual, see Operator's Guide.
Heart Rate Belt Bluetooth Pairing
For instructions to use and pair a bluetooth heart rate belt, see the Pairing with your Heart
Rate Belt chapter in the Operators Guide, see Operator's Guide.
Service and Maintenance
All information regarding the console installation, operation, service, and maintenance is
provided in the SPINNING® STUDIO Owner's Manual, see Operator's Guide.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 64
7 Spinning® Studio Console
Console installation and Set Up