Precor Spinner Ride Series User Manual

Belt Drive Issues
Applies To
All belt drive spinner series bikes.
Issues
Issues related to the belt drive bikes:
ISSUE CAUSE SOLUTION
Excessive belt
noise.
l Belt tension out-
of-spec.
l Worn belt.
Verify and adjust belt tension, see "Belt Drive
Tension Adjustment" on page10.
If tension is within spec, inspect belt condition
and replace if worn, see "Belt and Flywheel
Replacement" on page22.
Pedal slips
when pedaling
with power.
l Loose belt, ten-
sion out-of-spec.
l Worn belt.
Verify and adjust belt tension, see "Belt Drive
Tension Adjustment" on page10.
If tension is within spec, inspect belt condition
and replace if worn, see "Belt and Flywheel
Replacement" on page22.
Belt comes off
pulley
l Loose belt.
l Misaligned belt
pulley alignment.
Verify and adjust belt tension, see "Belt Drive
Tension Adjustment" on page10.
Check the front to rear belt pulley alignment.
Cannot be adjusted, check the left/right flywheel
axle bracket condition or possible a bent frame.
See Also
"Troubleshooting" on page58
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 60
6 Troubleshooting
Belt Drive Issues

Precor Spinner Ride Series Specifications

General

Brand	Precor
Model	Spinner Ride Series
Category	Exercise Bike
Language	English