6. Inspection, maintenance and desludging
Premier Tech 24 / 64 Solido SMART
DOKK5110E 15.04.2020
6.2 Monthly in-house inspection
As a qualified operator, you must perform the following work on a monthly basis or
have it performed by a company commissioned by you:
• Perform a visual inspection of the outflow (and in the inspection chamber if necessary) to
check for sludge output.
Note:
Sludge output endangers the ability of any downstream filtration plants to
operate.
• Check the inflow and discharge for blockages (visual inspection).
• Check the plant for any floating sludge.
• Enter the operating hours of the aggregates into the operations logbook (also see
chapter “5.7 Important documents for operation and maintenance”).
The manufacturer also recommends
• Perform a check for the formation of bubbles and of the lifter pump function.
Note:
The consistent formation of bubbles and unrestricted lifter pump operation are
extremely important for the treatment procedure. Contact the maintenance
service if there is a reduction in performance due to reduced compressed air
performance (a measurement of the tube diffuser counter pressure is required,
contact Premier Tech if required).
To Next Page
Loading...