ENGINE OPERATION
Engine
compartment
1
16
15
2
13
12
Component identification:
1 . Engine coolant tank
2.
Rear electrical panel
3.
Engine oil pressure gage
4. Engine
011
reserve tank
5.
O
il
reserve tank valve
6. Water temperature gage
7.
Engine air filter
8.
Engine primary fuel filter
The following controls are used to start and stop engine
from the operator's compartment.
ctlgnition
switchn
is used to start and stop the engine,
and also to activate electrical circuits. To start engine,
rotate key to
11STARTn
position. then release it as
soon
as
engine starts. With key set to
ccON11
posiUon.
electrical circuits are activated. Turn key to
uOFF11
position to stop engine and electrical circuits.
<CEmergency
stop
switch>1
is used to stop the engine
in
an
emergency situation. Push
on
button to activate.
18
3 4 5 6
11
10
9
9. Alternator
10.
A/C
compressor
11
. Water filter
12. Belt tensioner
13
. Muffler
14. Engine secondary fuel filter
15. Radiator fan gear box
16. Power steering oil tank.
1
8
Refer to uEngine emergency
stop11
for complete ope-
rating instructions
(not
required
on
turbocharged
engine).
Starting
engine
from
driver's
compartment
1. Make sure the remote control switch in rear panel is
set for front operation and the battery cut off switch is
turned on.
2. Make sure that the parking brake control button is
pulled all the way up, so that the spring loaded parking
brakes are applied.