EasyManua.ls Logo

PREVOST XL - Battery Compartment; Engine Compartment; Spare Wheel and Tire Compartment

PREVOST XL
54 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
To close baggage compartment doors, first release
safety lock then pull handle rod
out
and
down
as far as
door
will allow, lift
up
lock operating handle
to
close
door
and push
down
handle to complete procedure.
Baggage compartment lights are controlled
by
auto-
matic switches which illuminate when compartment
doors are opened.
•CAUTION:
Do not
drop
or
slam baggage doors.
This can only damage
door
and I
or
locking mechanism
and will not latch the door.
WARNING: Always be sure baggage
doors
are
properly secured in opened
or
closed position.
Battery
compartment
Batteries are accessible behind the R.H. engine side
door
. Four 12 volt-batteries are used and they are
of
the maintenance-free type.
The battery main switch is located directly over the
batteries. By moving battery main switch to «OFF»
position, all electrical supply from the batteries is
cut
off.
CAUTION: When
your
vehicle is parked overnight
or
for a longer period
of
time. you should set battery
main switch to
«OFF11
position.
34
Engine
compartment
Side-hinged engine compartment
doors
are secured
by
lock hand le located
on
the rig ht hand
door
.
To
open
doors, turn lock release handle and pull
out
doors
.
Doors are held in open position
by
a mechanical locking
device located at each
door
top section. To close doors,
first release mechanical locking device
by
pushing it
with fingers, then push doors back to closed position,
always starting with driver's side
door
.
Spare
wheel
and
tire
compartment
Spare wheel and tire are stowed in a compartment
behind front bumper. Wheel nut wrench can be used
to unscrew
the
two bumper retaining bolts. Front bumper
and compartment
door
will then lower to open position.
To pull
out
spare tire, loosen turnbuckle to release
support and tire carrier assembly. Tire can then be
easily pulled
out
using support as a rail extension.
Spare
wheel
and
tire
compartment
1. Holding chain.
2.
Support and rail extension .
3 Tire carrier pull-out strap.
CAUTION: The two
bumper
retaining bolts should
be checked to make sure they are firmly tightened
after compartment
door
has been closed.

Table of Contents

Related product manuals