A driver's light switch located near the entrance
door
can be operated manually and cancelled from the
dr
iver's position by using driver's light switch located
on
the side switch panel.
On
vehicles eQuipped with a central door, the entrance
stepweH
is automatically illuminated when the
door
is
opened. Also, two additional storage compartments
are provided: one is located at the right front corner
of
the vehicle and the other one is located under the en-
trance stepwell, as shown on the next illustration.
On vehicles equipped with an air doorlock. entrance
door
can
be
Jocked
or
unlocked from driver's position
by using the air
door
lock switch located on the switch
panel to the right
of
the steering wheel.
Compartment doors
The engine side doors can be opened by pulling the
release handle and then pulling
on
the
door
.
J
The evaporator and condenser compartment doors
can
be
opened by removing the retaining screws with
a Philips head screwdriver and then pulling on the
door.
36
The following doors ( #7, 8, 10, 13) can be opened
by turning the slotted head screw one quarter turn
counterclockwise and then pulling on the
door.
• CAUTION: A special care must be taken not to
damage the paint around the opening screw with the
screwdriver.
Exterior
mirrors
Your vehicle is provided with two exterior mirrors which
can be easily adjusted by observing the following method.
Mirror head can
be
rotated by loosening the adjusting
screw located at the base
of
the
mirror
head. Adjust to
desired position, then tighten adjusting screw firmly.
Mirror head can also be tilted up
or
down. To adjust,
use an "Allen" key and loosen the adjusting screw
located at the
mirror
end
of
the
mirror
arm. Position
mirror head as reQuired, then tighten adjusting screw
firmly.
Mirror arm angle can
be
adjusted in
order
to obtain
desired vehicle width. To adjust, loosen adjusting screw
located at body end of
mirror
arm. Position
mirr
or
arm
as
desired, then tighten adjusting screw.
To Next Page
Loading...
