LIGHTS
All interior and exterior lights can be illuminated with
ignition key in
on
or
off position. Switches are located
in driver's compartment and they control all lights with
the exception of engine
and
baggage compartment
lights, stoplights and back-up lights. Operation of lights
and light switches is given below.
Head,
markers
and
tail
lights
Head, markers, tail, license plate and instrument panel
lig his
are controlled by a single switch. Push to operate.
A hand operated
dimmer
switch is
mounted>oon
the
11multifunction» lever. Pull
or
push the lever to select
high
or
low
beam.
When high beam is
selected, a blue indicator lights
up
to inform the driver that the lights are
in
high position.
Fog
lights
Fog light switch will activate f
og
lights as well as tail and
marker
lights.
Fog light switch is located
on
front switch panel at the
right of driver.
Before using fog
lights. plastic protective rog light covers
must be removed by
pulting
on
their outer edge.
• CAUTION:
Do
not
operate fog lights when vehicle
is stopped for
more
than two (2) minutes as this may
reduce the
life
of
the fog light bulb. Never operate fog
lights with protective covers ,on.
Driver's
lights
Driver's light switch is located
on
side switch panel to
the
left
of
driver. Driver's light switch set to
on
position
wi
ll
activate the two front cei
li
ng lights above driver. It
can be cancelled by the other driver's light switch,
which
is
located
on
the dashboard, near the entrance
door
.
On vehicles equipped with a central door, the entrance
stepwell is automatically illuminated when the
door
is
opened.
Baggage compartment
lights
Baggage, steering and front electrical compartment
lights are automatically illuminated
when
appropriate
compartment
door
is opened.
30
Engine compartment light can be illuminated
by
ope-
rating the corresponding switch
which
is located
at
the
rigth
end
of
the rear electrical panel.
Directional
signal
switch
Directional signal switch is mounted
on
the
11multi-
function» lever, left
of
the steering column. With switch
lever up, front and rear turn signal lights flash
on
and
off
for
a right turn. With lever
down,
corresponding left
lights flash
to indicate left turn. In each case, turn signal
indicator flashes to indicate lights are operating. When
turn has been
completed, lever will return to neutral
position.
To
signal a lane change,
move
the lever
part
way to
the first stop, and
hold it there. The lever will return
to
neutral position when you release it.
Hazard
warning
flasher
switch
Hazard warning flasher switch is mounted
on
the dash-
board
panel. When switch is pushed in, all turn signal
lights flash simultaneously.
Marker lights will also flash.
Push again to release.
•
WARN
I
NG:
cc
Hazard» flashing lights should always
be turned on, day
or
night, when
your
vehicle is stop-
ped
along a highway
for
any reason, especially in case
of
emergency.
To Next Page
Loading...
