Driver's
seat
Two
(2)
different types
of
driver's seats are available.
The standard type is the
1clSRl11
seat with mechanical
suspension. The ccNATIONALu seat is also available
upon request. Both types can be equipped with air
suspension.
ulSRI»
seat
«ISRln seat can be adjusted to the
most
comfortable
position for the driver
by
using the following procedure.
3
2Q_
1
~
~
C::J
Nbt
4
~
5~
2
&~
7
~
8
~
•
On
«I
SRl11
seat equipped with
air
suspension, the sus-
pension is
self adjusting to the weight
of
the driver. thus
deleting the suspension adjustement
knob
(6).
SEATS
uNATIONAL»
seat
On
vehicles equipped with a
cc
National11
seat, the driver's
seat may be adjusted fore and aft by pushing
on
the lever
located
at left front
of
seat. When seat is positioned,
release
lever. The backrest
may
be tilted
by
pulling the
back
tilt
knob
at the left rear side
of
seat. To return
backrest to a forward position, grasp seat back and
pull forward while pulling tilt knob. The back
of
seat
cushion can be tilted
up
or
down
by grasping the
cushion tilt lever at left center of driver's seat and turning
forward to lower and backward to raise. To adjust seat
height press
down
lever
on
right side
of
base and
lower seat to bottom position.
release lever and pull
seat
up
to desired height. Release seat
and
it will lock in
place.
uNATIONAL
11
seat (mechanical)
1 . Onvers
seat
sa
fety bel
t.
2. Drivers seal h
e1
ghl
setting.
3.
Fronl and ba
ck
se
ll
ing
lever.
4. Cushion tilt selling.
5. Backresl lill setting
I
23
To Next Page
Loading...
