30
closer to the Printer. Subtract from the current value to move the tear point away
from the Printer. The value is automatically saved as soon as you set it.
• Left Margin Offset. This value moves the printed label left or right. Add to the
current value to move the printed label to the right. Subtract from the current
value to move the printed label to the left.
Note: Before adjusting this value make sure the label stock is properly load-
ed so that there is no gap between the edge of the liner and the fixed throat guide. Any
gap at this point will greatly affect the Left margin offset value needed to align the
label. Also, if you adjust the value with improperly loaded label stock you will have to
adjust it again if you load the label stock correctly the next time.
• Top of Form (TOF). This value moves the print start position up or down on the
label. Add to the current value to move the printed label down or toward the
Printer. Subtract from the current value to move the printed label up or away from
the Printer. The value is automatically saved as soon as you set it.
You may have to make several adjustments to one
or more of these values. After each adjustment you
can click the Test button to print a small test pattern
on the label. This will help you find the proper
alignment value.
To Next Page
Loading...
Need help?
General
