Prodigit 3260A Series - Page 53

PRODIGIT 3260A Series Operation Manual 47
IL
Purpose：
：：
：
To set the lower limit value of threshold current.
Command syntax：
：：
：IL{SP}{NR2}{；|NL]
Description：
：：
：
This command is to set the lower limit value of threshold current. When load sink
current is lower than this lower limit value, NG indicating light will come on to indicate
〝NO GOOD〞.
For Example：
：：
：
IL 0.05 ; To set the lower limit value of threshold current.
IH
Purpose：
：：
：
To set the upper limit value of threshold current.
Command syntax：
：：
：IH{SP}{NR2}{；|NL}
Description：
：：
：
This command is to set the upper limit value of threshold current. When load sink
current is high than this upper limit value, NG indicating light will come on to indicate
〝NO GOOD〞.
For Example：
：：
：
IH 10.0 ; To set the upper limit value of threshold current is 10.0 A.
WL
Purpose：
：：
：
To set the lower limit value of threshold power (W).
Command syntax：
：：
：WL{SP}{NR2}{；|NL}
Description：
：：
：
This command is to set the lower limit value of threshold power (WATT). When power
(WATT) is lower than this lower limit value, NG indicating light will come on to
indicate〝NO GOOD〞.
For Example：
：：
：
WL 0.05 ; To set the lower limit value of threshold power (W) is 0.05 W.
WH
Purpose：
：：
：
To set the upper limit value of threshold power (W).
Command syntax：
：：
：WH{SP}{NR2}{；|NL}
Description：
：：
：
This command is to set the upper limit value of threshold power (WATT). When
power (WATT) is high than this upper limit value, NG indicating light will come on to
indicate〝NO GOOD〞.
For Example：
：：
：
WH 250.0 ; To set the upper limit value of threshold power (W) is 250.0 W.