3.4. FCC Notes USA
The devices described in this device manual may only be used in mobile or stationary systems in which the distance
between antennas and persons is at least 20 cm. The antennas must further not be co-located or operated in
conjunction with any other antennas or transmitters.
NOTICE
This device has been tested and found to comply with the limits for a Class B digital device
pursuant to part 15 of the FCC rules. These limits are designed to provide adequate protection
against harmful interference in a residential installation. This device generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the
instructions,may cause interference to radio communications. There is no guarantee that
interference will not occur in a particular installation. If this device does cause interference to radio
or television reception, which can be determined by switching the device on and off, the user is
advised to try to correct the interference by one or more of the following measures:
* Realign the receiving antenna or put it in a different place.
* Increase the distance between the device and the receiver.
* Connect the device and the receiver to different supply circuits.
* Consult the dealer or an experienced radio/TV technician for help.
NOTICE
Loss of FCC certification possible.
Only use antennas with a maximum antenna gain of +3.8dBi for Bluetooth and WLAN 2.4GHz-
Band and +5.5dBi for WLAN 5GHz-Band.
Changes or modifications to the device not expressly approved by the manufacturer can void the
user’s authority to operate the device under FCC rules.
CANlink wireless 4000 Device Manual
To Next Page
Loading...
