5.2. Connecting the Device
WARNING
Overload damage due to malfunction.
Risk of severe or fatal injury.
- To limit power in the event of malfunction, secure the DC power supply circuit during installation
with an external 1A fuse.
NOTICE
Risk of property damage.
- The device must be installed, connected, and commissioned by a qualified technician.
- Ensure the power supply is disconnected before connecting the device.
- Only use components from the starter kit or the available accessories. Refer to chapters [Starter
Kits] and Software and Accessories.
If you have any questions or anything is unclear, please contact our support before getting started. See
chapter Service and Support.
CANlink wireless 4000 Device Manual
To Next Page
Loading...
