PROEMION CANlink wireless 4001 - Page 60

5.3.2. CAN – Mobile Device / PC Interface P2P WLAN Access Point mode
WLAN
Table 26. CAN – Mobile Device / PC Interface P2P WLAN Access Point mode, Tab WLAN
Section Parameter Setting
WLAN
Settings
Enable
Enabled
WLAN
Settings
Operating Mode
Access Point
WLAN
Settings
SSID Enter user friendly name of the WLAN Access Point (e.g. CANlink wireless
SN123456).
Make a note of the SSID name for the subsequent setup of the WLAN connection.
WLAN
Settings
Authentication
Type
Select the authentication type (e.g. WPA/WPA2 Mixed)
WLAN
Settings
Authentication
Key
Enter secure authentication key (minimum key length: 8 digits).
Make a note of the key for the subsequent setup of the WLAN connection.
IP Settings DHCP Mode
Server
IP Settings Host name Enter a name for the device within the WLAN.
IP Settings IP address
192.168.0.34
IP Settings Network mask
255.255.255.0
IP Settings Gateway address
192.168.0.1
IP Settings Primary DNS
Server
192.168.0.1
IP Settings Secondary DNS
Server
192.168.0.2
Bluetooth
Table 27. CAN – Mobile Device / PC Interface P2P WLAN Access Point mode, Tab Bluetooth
Section Paramete
r
Setting
Device Configuration Enable
Disabled
Wireless Peers
Table 28. CAN – Mobile Device / PC Interface P2P WLAN Access Point mode, Tab Wireless Peers
Section Paramete
r
Setting
Servers TCP
Enabled
Server Configuration Enable
Enabled
Server Configuration Type
TCP
Server Configuration Type
30000
Clients - -
CANlink wireless 4000 Device Manual